20A Buck Step Down Converter About
Step Down Buck Converter 300W 20A Adjustable DC-DC Widely used in industrial Automation, scientific Research Equipment, LED Lighting, air Purification, civil equipment,
solar panel voltage regulator, battery charging wind turbines and so on
High-power LED driver Step Down Buck Converter.
Lithium battery(or lead accumulator) charge.
Vehicle-mounted power supply.
Low voltage system power supply.
6V, 12V, 14V, 24V battery charge.
On-board laptop power supply.
Regulated power supply.
Low voltage power supply system
20A Buck Step Down Converter Features
Scope: High-power LED constant current driver, rechargeable lithium batteries 4V, 6V, 12V, 14V, 24V battery charging; nickel-cadmium nickel-metal hydride batteries (battery) charging, solar panels, wind generato.
Output voltage: continuously adjustable (1.25-36V) (applied to the input voltage is higher than the output voltage applications can boost).
Turn lights Current: current value * (0.1), turn the lamp current, and constant value linkage, such as the constant value of 3A.
Turn the lamp current is set to a constant current of 0.1 times (0.1 x 3A = 0.3A), when the constant 2A, when adjusted to the current value, then turn the lamp current constant current of 0.1 times (0.1 x 2A = 0.2A).
This veion is fixed 0.1 times (actually turning the lamp current value is probably not very accurate) is full of instructions for charging.
Minimum pressure: 1V.
Output Ripple: about the ripple 50mV (without noise) 20M bandwidth (for reference) Input 24V Output 12V 5A measured.
Operating temperature: -10 to + 75 (please note the actual use of the power tube temperature, the temperature is too high, please enhance heat dissipation).
Specifications:
Color: Silver
Material: Metal
Size: Approx. 60 x 52 x 27mm / 2.36 x 2.05 x 1.06”
Input Voltage: DC 6-40V (10V to 40V is suggested)
Output Voltage: DC 1.2-36V
Output Current: 20A(max.), 15A (suggested)
Efficiency: 97% (24V to 12V, 20A)
Output Ripple: ≤50mV
Wiring Method: Terminal
Short Circuit Protection: Self-recovery (cannot short circuit for a long time) en.wikipedia.org
VO+: Output positive
VO-: Output negative
+IN: Input positive
-IN: Input negative
CV: Output voltage adjustment
CC: Output current adjustment
EN: Enable, low voltage level shut off output; suspension, high voltage level is effective
When input and output is common grounded, no-load CV output constant voltage, CC output constant current
Working Temperature: -10°C-75°C
Home » All Products » Hw29 Hw 29 Hx711 Weighing Sensor Load Cell Amplifier Module Analog To Digital Converter Pressure Sensor
Hw29 Hw 29 Hx711 Weighing Sensor Load Cell Amplifier Module Analog To Digital Converter Pressure Sensor
₨ 160
16 sold - 15 sold in last 28 days
| Weight | 1 kg |
|---|---|
| Dimensions | 2 × 2 × 2 cm |
| Quality | Orignal |
Be the first to review “Hw29 Hw 29 Hx711 Weighing Sensor Load Cell Amplifier Module Analog To Digital Converter Pressure Sensor” Cancel reply








Reviews
There are no reviews yet.